Bộ cài đặt địa chỉ VF9000

Mô tả sản phẩm Bộ cài đặt địa chỉ VF9000

The Hand Held Programmer is designed for use with all analog sensors and modules.
Address Setting
1. Install sensor onto programmer, ensuring that sensor protrusions align with programmer grooves.
2. Press the left gray button to switch programmer on. A battery check message will appear followed by the device’s address (Unprogrammed sensors will read address 127).
3. Set the required address by incrementing the left and right gray buttons (the display will show three red flashing dots if the address being programmed is different from the device’s current address).
4. When the desired address is present, press the blue button to store that address. The three red dots on the display will no longer be present.

Standard Features

• Compact unit
• Easy to use
• Provides address setting and reading
• Can be used on both sensors and modules
• Has the diagnostic ability to display the analog value
• Over 8000 address settings from one battery

Display Messages

• bAt On upon power up (battery check). Also on when battery is low. Low battery good for up to 3,000 address setting operation.
• E0 Attempting to set an address beyond 127
• E1 Attempting to program an address with no device connected
• E2 Cannot find device after power up
• E3 Invalid sensor response
• E4 Cannot find the device program
• E5 Device read error
• E6 Fail during analog value reading